Hydraulic Floor Jack 3T is available in a variety of si […]
Hydraulic Floor Jack 3T is available in a variety of sizes, capacities, and alloys to provide versatile use for storage and transportation. But have you ever wondered what happened in jacks, even a three-ton vehicle can boost your power? The answer lies in the name, which is an ancient technology of hydraulic machinery, hydraulic technology, dating back to about 200 BC. The study of hydraulics has spanned a huge area, but especially here, the use of fluids to transmit electricity; that is, the transmission of your arm's downward movement to the upward movement of your vehicle.
The handle of your floor jack 3t is attached to a yoke that is connected to a bottle jack device, the main working mechanism. Inside the bottle, or the reservoir is a cylinder with a piston inside. Underneath them there are several passages, two check valves (including spring balls) and a release valve, at the end of which are the pump cylinder and the piston it contains, and the handle to which it is connected to your jack . Filled reservoirs are hydraulic fluids, which are an important part of the entire organization.
When you lift the handle of the jack, the pump piston rises, pumping the liquid out of the reservoir and the pump cylinder is filled with a certain amount of liquid. When you lower the handle and inject power into it, the pressurized fluid is confined by the check valve and enters a different channel and fills the master cylinder, pushing up the lift piston. Pull the handle fully and you can even lift a three-ton vehicle.
When you no longer need to raise the floor jack 3t, slightly rotate the release valve and drain the fluid from the main cylinder back to the tank so that the piston will return to the starting position. In floor jacks, the jack unit is parallel to the ground and the piston is connected to the arm through a special joint; the piston pushes the bottom of the arm forward, the top of the arm is raised and the saddle and the vehicle are lifted.