Floor Jack 3T is a kind of important hydraulic componen […]
Floor Jack 3T is a kind of important hydraulic component that is widely used in the load-carrying vehicles or mobile equipment to support the weight of the equipment and adjust the equipment level. It is mainly used in the factories, mines, transportation and other departments as vehicle repair and other lifting, support and other work. It is a lightweight lifting device that uses a rigid lifting device as a working device to lift a heavy object through a top bracket in a small stroke.
Instructions for use:
1.Floor jack 3T must check whether all parts are normal.
2.The head support is aimed at lifting the load near the center of gravity, and the four-wheel position is placed on a relatively flat and solid surface to prevent the body from sagging.
3.When using the floor jack 3T, rotate the pressure relief cap on the joystick clockwise, and then pull the pressure relief lever forward and backward, and the lifting and lifting of the support head will increase the lifting height up to the rated height. When the pressure drops, the pressure relief cap will loosen slightly and the lifting arm will gradually fall.
4.When operating floor jack 3T, the product performance parameters should be strictly observed.
5.The center of gravity must be chosen moderately, and the jacking point should be reasonably selected. The bottom should be flattened, and soft and hard ground conditions should be taken into consideration. Whether to put tough wood or not and place it in a stable manner should prevent it from sinking or tilting.
6.When using, firstly connect the quick joint of the hand pump to the top, then select the position and screw the oil drain screw on the oil pump to work. To lower the piston rod, loosen the hand pump manually counter-clockwise and the cylinder is unloaded and the piston rod is gradually lowered. Otherwise it will be dangerous to drop too fast.